FRIGIDAIRE FRA123KT1 - Manual (Page 8)

8
Installation Instructions
Cut side channel seal into 2 equal lengths. Remove the protective backing and apply it to the rear side of the
cabinet side channels, starting just below the panel frame assembly. Pinch off excess length so the seal is even with
the bottom of the cabinet side channel (FIG.29).
To remove front as shown (FIG.30)
1. Remove the two front retaining screws from the front frame.
2. Press firmly on each side of the metal case close to the front, approximately 2/3 of the way down.
3. While pressing on the sides of the metal case, gently pull the front out and lift up to release it from the case.
4. Then release the electrical coupler plug.
NOTE: DO NOT push or pull air direction louvers.
Place the air conditioner in the window opening as shown (FIG.31). It should sit on the platform assembly
so that the window panel frame and the cabinet side channels are against the top and side window jambs. Side
channels should overlap side window jambs equally.
Apply side
channel
seal to side
channels just
below edge of
panel frame.
Front
Retaining
Screw
'ULOOWZR ƎGLDPHWHUSLORWKROHVin the top window jamb in line with the partially plugged holes in the panel
IUDPH6HFXUHWKHSDQHOIUDPHWRWKHZLQGRZMDPEZLWKWZR[ƎVHOIWKUHDGLQJVFUHZV,IDGGLWLRQDOKROGLQJLV
necessary, two screws may be used on the sides of the panel frame as well.
Drill two screw-clearance holes LQWKHFDELQHWVLGHFKDQQHOV QHDUERWWRP DQGWZR ƎGLDPHWHUSLORWKROHV
LQWKHVLGHZLQGRZMDPEV6HFXUHWKHFDELQHWVLGHFKDQQHOVWRWKHZLQGRZMDPEVZLWKWZR[ƎVHOIWKUHDGLQJ
screws. When doing this, be careful not to twist the side channel seals with the screws.
NOTE: Inserting screws will prevent the air conditioner from being pushed into the room.
To replace the front first reconnect the coupler plugs, make the exhaust control positioned through the front
in the proper location. Gently push the front into position on the cabinet. It should click into place. Then replace the
retaining screws that holds the panel in place.
Do not push against or pull upon the front panel louvers.
FIG.29 FIG.30
FIG.31
34
35
36
37
38
39