Casablanca Fan Company Panama Halo 66HXXF - Manual (Page 4)

4
crossbar mounting bracket installation
JOIST
CEILING
WIRING
CrOSSbAr
mOunTIng
brACKET
FLAT
WASHER
GREEN GROUND
WIRE
CEILING FAN
AppROVED
WIRING BOx
RIDGE SIDE
DOWN
AppROVED OUTLET
BOx HARDWARE
note: After removing the old fixture, check the outlet
box to insure that it is supported by a joist or beam
across its upper surface. If not, a 2” x 4” stud must
be installed.
Step 1. Remove the knockout plug in the center of the
outlet box or drill a 1 / 2
” hole for the lag screw to pass
through. Then drill a 1 / 4
” guide hole into the joist or beam
to a depth of 3”.
Step 2. Route the outlet box wires through the keyhole
slot of the crossbar mounting bracket as shown. Attach the
crossbar mounting bracket to outlet box with screws pro-
vided, assuring that the outlet box wires are not pinched
by the washer.
CAUTION: To reduce the risk of personal
injury, use only the mounting hardware pro-
vided with the approved outlet box to install
the crossbar mounting bracket.
WARNING!
SUppORT DIRECTLy TO
BUILDING STRUCTURE ONLy.
Step 3. With the large washer attached, pass the lag
screw through the center hole of the crosbar mounting
bracket and screw into guide hole. Tighten until outlet
box is firmly mounted to beam. This box must be firmly
secured to the ceiling. We recommend that the ceiling
fixture outlet box be of sufficient capacity enabling it
to support the weight of fan and light fixture under any
conditions.
LAG
SCREW
LAG SCREW INSTALLATION
LARGE
WASHER
CANOPY hARDWARE
CANOpy LOCK WASHER
(4)
CANOpy SCREW (4)
CANOpy
CANOpy
HATCH