Chauvet Work Light - Manual (Page 17)

Operation
COLORado™ 2 Tour User Manual Rev. 02b -13-
Continued from previous page
White Balance
This setting allows the user to select the white color shown by the COLORado™ 2 Tour
when the DMX controller’s Red, Green, and Blue faders are set to “255”.
1) Press <MENU> repeatedly until CAL2 shows; press <ENTER> to accept.
2) Press <MENU> again at RGBW.
3) Use <UP> or <DOWN> to select a color (Red, Green, or Blue).
4) Use <UP> or <DOWN> to select a color value (0~255).
5) Repeat for the other colors.
6) Press <MENU> to exit once done.
TOUR Notes These notes intend to clarify the way the TOUR DMX personality works.
Master Dimmer • Channel 1 controls the intensity of the currently projected color.
• When the slider is at the highest position (255) the intensity of the output is at its
maximum.
Red, Green & Blue,
& White Color
Selection
• Channels 2, 3, 4, and 5 control the intensity ratio of each of the Red, Green, Blue,
and White LEDs.
• When the slider is at the highest position (255) the intensity of each color is at its
maximum.
• You can combine channels 2, 3, 4, and 5 to create over 1 billion colors.
Color Macros • Channel 6 selects the required Color Macro.
• Channel 6 has priority over channels 2, 3, 4, and 5 (disables faders).
• Channel 1 controls the intensity of the Color Macro.
Strobe • Channel 7 controls the strobe frequency (not the intensity) of channels 2~6.
• Strobe 1 is with RGB in-step.
• Strobe 2 is with RGB out-step.
• Strobe 3 is a pulse strobe (fast on/slow off).
• Strobe 4 is a pulse strobe (slow on/fast off).
• Channel 7 strobes channels 2, 3, 4, and 5 when not running macros, allowing the
individual faders (R, G. B, and W) as well as channel 1 (D) to control the output
intensity.
• Channel 7 strobes channel 6 when running macros, allowing channel 6 to select
the macro and channel 1 to control the output intensity.
ID Address
Selection
• Channel 9 selects the target ID address.
• Each independent DMX address may have up to 66 independent ID addresses.
• An ID address of 0 will activate all ID address locations.
Auto • Channel 8 selects the preset Auto programs AT. 01~10 or the custom Auto
programs PR. 01~10.
• When activating the custom Auto programs PR. 01~10, it is possible to control the
Step Time and Fade Time parameters using channels 2 and 3 respectively.
• Channel 8 has priority over channels 2, 3, 4, 5, 6, and 7.
Dimmer Speed • Channel 10 is for selecting the dimmer mode and speed. When Dimmer is set to
Off, RGBW and Master Dimmer are linear. Otherwise, Dim1 is the fastest dimmer
curve, while Dim4 is the slowest.