Crosley Radio CR2401A - Manual (Page 2)

The exclamation point
within an equilateral
triangle is intended to
alert user to the
presence of important
operating and
maintenance (servicing)
instruction in the
literature accompanying
the appliance.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
The lighting flash with
arrowhead symbol, within
an equilateral triangle, is
intended to alert user to
the presence of uninsulated
"dangerous voltage" within
the product's enclosure
that may be of sufficient
magnitude to constitute
risk of electric shock
to persons.
CAUTION: TO REDUCE
THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE
COVER (OR BACK). NO
USER - SERVICEABLE
PARTS INSIDE. REFER
SERVICING TO QUALIFIED
SERVICE PERSONNEL.
Specification
Frequency Range : AM 530 - 1700 KHz
: FM 88 - 108 MHz
Power Supply : AC 120V ~ 60Hz
Power Consumption : 50W
Speed
: 33 1/3, 45, 78 RPM
Speaker : 4” 8ohm 5W x 2
Replacement Needle : NP3
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
ANOTHER
AUDIO COMPONENT AUX IN
R
(RED JACK)
AUX IN
L
(WHITE JACK)
AUX IN
R
(RED JACK)
Audio Connections
Audio / Connections
LINE IN
Using the LINE IN will allows you to hook up
additional external audio components and listen to
them through your unit. Any component with an
audio output such as a Tuner, can be connected by
using the correct cables. This unit uses standard
RCA cables. Simply plug the red and white
connectors on one end of the cable to the red and
white Aux In jacks on the back of your unit. The
other end of the cable will plug into the Audio Output
jack on the external component. For more information
on hooking up the external component, see the
owner’s manual for that component.
LINE OUT
Using the LINE OUT will allow you to run the audio
from your unit into a home stereo, television or other
stereo source. To make this connection, you will
need standard RCA cables. Plug the red and white
connectors on one end of the cable into the red and
white Audio Output jacks on the back of the unit.
The other end of the cable will plug into the Aux
Input jacks of your selected component. For more
information on hooking up to the external component,
see the owner’s manual for that component.
NOTE: You can still listen to your unit when using the Audio
Output feature
LINE IN
LINE OUT
AUX IN
L
(WHITE JACK)
L
R
AUDIO IN
L
R
AUDIO OUT