Caldera SST305 - Manual (Page 10)

Phone 800-725-7711 www.calderacorp.com Fax 800-962-3072
10
Using A Burner
Select a burner by touching its corresponding ON/OFF key. The ON/OFF keys are arranged to mirror
the burner locations. The 8 segment LED will blink
'p' for program. Press the up or down arrow. If the
down arrow is touched the burner will come on at level '4' . If the up arrow is pressed the burner will
come on 'H' (high). You may then move to the desired setting using the up and down arrow keys.. The
programming mode (blinking 'p' )lasts for 10 seconds.
Selecting A Power Level
A brief touch to the control arrows will adjust the power by 1/2 increments (21 settings). This is
indicated by a beep and circular LED to the right of the seven segment LED. A steady touch will scan
through the eleven whole number settings.
Settings L, 1 thru 3 1/2 are the simmer settings, your gas burner will cycle on and off for varying
amounts of time depending on the setting. All settings of 4 and above produce a steady flame.
Turning A Burner Off
A brief touch to the appropriate burner's ON/OFF key will turn the burner off. You can turn all burners
off at the same time by touching the lock icon for 1 1/2 seconds.
Power failure
In case of a power failure your unit will not operate. It will "fail / safe". Each burner and the overall
safety valve will shut the flow of gas of automatically.
Flame height and Appearance
Yellow Flame, call your
gas company for service.
Yellow tipped blue flame,
normal for L.P.
Soft blue flame, normal
for natural gas.
Grates And Burner Caps
Grates and burner caps may be washed with hot soapy water or placed in the dishwasher. If needed, mild
abrasives may be used. Allow grates and caps to dry well before replacing them. Use care replacing the
burner caps so as not to damage the thermocouple and the hot wire igniter.