Caldera SST305 - Manual (Page 5)

Phone 800-725-7711 www.calderacorp.com Fax 800-962-3072
5
Before Using Your Gastop:
READ THIS MANUAL
1.
Insure proper installation and servicing. Have the gastop installed by a qualified technician.
Installation must conform to local codes or, in the absence of local codes, with the National Fuel
Gas Code, ANSI Z223.1/NFPA 54 and CAN/CSA-B149.1 Natural Gas
and Propane Installation Code.
2. The gastop you have purchased uses either LP or natural gas. It cannot be converted from one to
the other. The proper fuel must be used.
3. Use only a 120 volt grounded outlet. Installation must conform to local codes or, in the absence
of local codes, with the National Electrical Code, ANSI/NFPA 70 and CAN/CSA-C22.1
Canadian Electrical Code, Part .
All gastops must be grounded for the controls to function
properly. Improper installation could destroy your electronic controls and void the warranty.
4. Do not use an extension cord.
5. Always unplug the unit before servicing
6. Know where your gas shut-off valve is and how to operate it.
7. Be sure all packing materials have been removed, including any tape on the surface or underside
of the unit.
8. Do not repair or replace any part of the unit unless specifically recommended in the Installation
or Use and Care manual. All other servicing should be performed by a qualified technician.
Safety Precautions:
1. Use the unit only for its intended purpose.
2. For safety reasons never use the unit to heat or warm the room.
3. When using an electrical appliance near the gastop, be sure that the cord of the appliance does
not come into contact with the burner area.
4. Do not leave children unattended in an area where appliances are in use. Teach them not to touch
the gastop.
5. NO ONE should ever be allowed to sit or stand on any part of the gastop or the area around the
gastop.