Harbor Freight Tools Model 93289 - Manual (Page 4)

Page 4 SKU 93289 For technical questions, please call 1-800-444-3353.
Note: Performance of the compressor (if powered by line voltage) may vary depending
on variations in local line voltage. Extension cord usage may also affect tool perfor-
mance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Air Connection
For best service you should incorporate a regulator and inline filter, as shown in the diagram
above. Hoses, couplers, regulators, and filters are all available at Harbor Freight Tools.
1. You will need to prepare a 1 /
4
”-18 NPS air connector (not included) to connect to the Air
Inlet (14) on the Spray Gun. First, wrap the
1
/
4
” air connector with pipe thread seal tape
before threading it into the Air Inlet (14). Connect the
3
/
8
” ID air source hose to a quick
connect coupler, and then to the Spray Gun.
2. Set the air pressure on the regulator to 40 PSI. Do not exceed 60 PSI.
3. Check the air connection for leaks. Disconnect from the air source.
Spray
Gun
Unpacking
When unpacking, check to make sure the product is intact and undamaged. If any parts are
missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.