Chauvet Model ST-200 - Manual (Page 9)

Appendix
ST-200 User Manual 9 Revision: 2004-11-02/11:23
General Troubleshooting
Applies to
Symptom Solution(s)
Lights
Foggers
& Snow
Controllers
Dimmers
& Chaser
Auto shut off Check fan thermal switch reset 9
Beam is very dim or not
bright Clean optical system or replace lamp
Check 220/110v switch for proper setting
9
Breaker/Fuse keeps
blowing Check total load placed on device
9
Chase is too slow Check users manual for speed adjustment 9 9 9
Device has no power Check for power on Mains.
Check device’s fuse. (internal and/or external)
9 9 9
Fixture is on but there
is no movement to the
audio Make sure you have the correct audio mode on the control
switches. If audio provided via ¼” jack, make sure a live
audio signal exists
Adjust sound sensitivity knob
9 9 9
Lamps cuts off
sporadically Possible bad lamp or fixture is overheating.
Lamp may be at end of its life.
9
Light will not come on
after power failure Some discharge lamps require a cooling off period before
the electronics in the fixture can kick start it again, wait 5 to
10 minutes before powering up
9
Loss of signal Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power cables or
black lights. 9 9 9 9
Moves slow Check 220/110v switch for proper setting 9
No flash Re-install bulb, may have shifted in shipping 9
No light output Check slip ring & brushes for contact
Install bulb
Call service technician
9
Relay will not work Check reset switch
Check cable connections
9
Remote does not work Make sure connector is firmly connected to device 9 9
Stand alone mode All Chauvet lighting fixtures featuring stand-alone functions
do not require additional settings, simply power the fixture
and it will automatically enter into this mode
9