Creek Audio STVG-989 - Manual (Page 18)

TROUBLE SHOOTING GUIDE
SOLUTION PROBLEM POSSIBLE CAUSE
Follow directions on page E7 for
“Making the Connections”.
No sound - If audio is
connected to TV or
VCR.
Source Selection on TV or
VCR is not correct.
No song lyrics appear
on screen.
Connect the video cable to the
Singing Machine’s VIDEO OUT
and to the TV VIDEO IN.
Using your TV remote to select
VIDEO input.
Connect from VIDEO OUT of the
system to the VIDEO IN of your
VCR or connect to an RF
Modulator and then to the TV
cable input. Refer to “Making the
Connections” on page E7.
Check the disc to be sure it is a
CDG. (See page E20 for details.)
Video cable is not connected
properly to the TV.
Source selector on TV is not
set to VIDEO.
Check disc to be sure it is clean.
(See page E15 for cleaning
instructions.)
A CDG is loaded but the
CDG indicator is not lit.
TV does not have video line
input.
17
Image is blurry.
Camera has not warmed up.
Camera lens is dirty.
Wait a minute for the camera to
warm up.
Clean the camera lens.
Camera lens is out of focus.
Adjust the lens of the camera by
slightly rotating either left or right
until the display is clear. Do not
overturn the lens.
Use your TV remote to select
VIDEO input. (Refer to page E8
under Common ways to configure
your TV or VCR)
Source selector on TV is not
set to VIDEO.
Ensure white and red patch cords
are securely inserted into both
The Singing Machine and the
TV/VCR.
Patch cords are not
connected securely.
Use your TV remote to select the
proper VIDEO input or select the
proper VIDEO input on the TV
itself. (Refer to page E8 under
Common ways to configure your
TV or VCR)
Source selector on TV is not
set to VIDEO.