Cub Cadet 59A40003727 - Manual (Page 6)

6
seCTion 2: labels found on loader
(QTY 2) 777D11290
On Both Sides
777S32188
INSTRUCTIONS
ASSEMBLY FOR FRONT END LOADER
1. PARK LOADER ON FIRM
LEVEL GROUND.
2. SLOWLY DRIVE THE TRACTOR
CLOSE TO THE LOADER. STOP
AND SET THE PARKING BRAKE.
3. CONNECT COLOR CODED
HYDRAULIC QUICK DISCONNECT
TO LOADER HOSES.
4. USE THE LOWER BOOM
CONTROL TO LOWER MASTS
ONTO RECEIVERS.
5. CONTINUE TO LOWER BOOM
UNTIL ALL WEIGHT IS OFF
THE FRONT TIRES.
6. LOCK LOADER MOUNTING
TUBE INTO RECEIVER WITH
LYNCH PINS.
7. ADD HAIR-PINS TO LYNCH
PINS (IMPORTANT TO PREVENT
LYNCH PIN LOSS).
DISASSEMBLY FOR FRONT END LOADER
1. PARK TRACTOR ON FIRM
LEVEL GROUND.
2. USE THE LOWER BOOM
CONTROL TO TAKE ALL
WEIGHT OFF OF FRONT TIRES.
3. REMOVE LYNCH PINS FROM
FRONT MOUNT ASSEMBLY.
4. USE THE RAISE BOOM
CONTROL UNTIL MASTS EXIT
THEIR RECEIVERS.
5. DISCONNECT THE COLOR
CODED HYDRAULIC QUICK
DISCONNECTS.
6. SLOWLY DRIVE AWAY FROM
LOADER.
1. READ AND UNDERSTAND
OPERATOR'S MANUAL
BEFORE OPERATING.
2. KEEP OTHERS AWAY WHEN
OPERATING LOADER.
3. DO NOT ALLOW CHILDREN
OR UNTRAINED PERSONS
TO OPERATE EQUIPMENT.
4. LOWER LOADER TO GROUND,
STOP ENGINE, SET PARK
BRAKE AND REMOVE KEY BEFORE
LEAVING TRACTOR SEAT.
5. FAILURE TO FOLLOW SAFETY
RULES CAN RESULT IN
SERIOUS INJURY OR DEATH.
IMPORTANT
TO PREVENT POSSIBLE
TRANSMISSION DAMAGE, ENGAGE
THE 4WD ONLY WHEN ADDITIONAL
TRACTION IS NEEDED WHILE
OPERATING IN LOOSE SOIL OR ON
SLIPPERY SURFACES (E.G. MUD,
SNOW), OR WHEN DESCENDING A
SLOPE. DISENGAGE THE 4WD
WHEN OPERATING ON FIRM, FLAT
SURFACES OR WHEN OPERATING
AT HIGH SPEEDS.
WARNING
777I22804
UP
DOWN
N
UP & DUMP
DUMP CURL
FLOAT
READ OPERATORS MANUAL BEFORE OPERATING
UP & CURL
DOWN & CURL
1 2
3
4
DOWN &
DUMP
Model Plate
777D11357
(QTY 2) 777I22850
777D11455
777D11356
BUCKET LEVEL
REFERENCE POINT
On Both Sides