Crimestopper Security Products SV-6910 - Manual (Page 3)

2
Figure 2
Installation 1:
1. Locate a suitable mounting location at rear of vehicle.
2. Use the supplied bracket to mark the mounting hole locations.
3. Drill two 3/16” holes for mounting hardware you are using. Drill a 11/16” hole in
the cable location. Route the cable into the vehicle and then insert the Grommet to
prevent water from pouring in.
4. Attach the camera-mounting bracket to the vehicle with the lens shroud on topside.
If lens shroud is on the bottom, then the camera must be removed from the bracket
and turned 180 degrees and then reattached to the bracket.
5. Route the camera cable towards display monitor.
6. Connect the camera cable to monitor.
7. Select camera image normal or mirror image by reverse image jumper. (Figure 1)
Camera Installation 2 (Viewing angle does not adjust)