Crimestopper Security Products SV-6910 - Manual (Page 4)

3
Figure 3
Installation 2:
1. Locate a suitable mounting location at rear of vehicle.
2. Use the camera backplate to mark the mounting hole locations.
3. Drill two 3/16” holes for mounting hardware you are using.
4. Use screws to attach the camera backboard to the vehicle with the lens shroud on
topside.
5. Route the camera cable towards display monitor.
6. Connect the camera cable to monitor.
7. Select camera image normal or mirror image by reverse image jumper. (Figure 1)
Specification
1. Signal System: NTSC
* 2. Image Display: Mirror Image or Normal Image Optional
3. Voltage: DC 12V
4. Current: 100mA
5. Image Sensor: CMOS
6. Horizontal Definition: 420 Lines
7. Viewing Angle: 130 degrees
8. Minimum Illumination: 0.3 LUX
9. Outer Dimensions: 2.52” (W) x 2.15” (H) x 1.73” (D)
10. Weight: 7 OZ
* Note: The camera can reverse the image by removing the reverse
image jumper at the end of camera cable.
WARNING
The SV-6910 Back up camera system is strictly a driver assistant device. It
should not be considered a safety device for any purposes. The
Manufacturer and distributors of the product do not guarantee or assume
liability for collision or damages that take place when backing up your
vehicle.