Crestron electronic ROOMVIEW CP-X4014WN - Manual (Page 16)

16
You can adjust or control the projector via a network from a web browser on a
computer that is connected to the same network.
• Internet Explorer ® 6.0 or later is required.
• If JavaScript ® is disabled in your web browser configuration, you must enable
JavaScript ® in order to use the projector web pages properly. See the Help files
for your web browser for details on how to enable JavaScript ® .
• It is recommended that all web browser updates are installed.
• If data is transferred via wireless and wired LAN at the same time, the projector
may not be able to process the data correctly.
NOTE
3. Web Control
3. Web Control
Refer to the following for configuring or controlling the projector via a web browser.
Make sure that your computer and the projector is connected via network, and
then start Web browser.
Enter the projector's IP address into URL input box of the Web browser as the
example below, and then press the Enter key or
button.
Example: If the IP address of the projector is set to 192.168.1.10:
Enter “http://192.168.1.10/” into the address bar of the web browser
and press the Enter key or click
button.
If a correct URL is input, and the projector
and your computer are connected to the
same network correctly, the selection
window as shown on the right will be
displayed.
You can choose to use the Projector
Web Control or Crestron e-Control
® as
a tool for controlling the projector. Click
one of them.
For more details, refer to 3.1 Projector
Web Control (
17) or 3.2 Crestron
e-Control ® (
42).
• If Crestron e-Control in the Network Settings (
21) is set to
Disable, the selection window above does not appear, but the Logon window of
the Projector Web Control is displayed.
• Crestron e-Control
® is created using Flash ® . You need to install the Adobe ®
Flash ® Player on your computer to use Crestron e-Control ® .
NOTE