Dell PowerVault 124T User Manual
Page 22
device is attached to, simply edit both lines.
LOAD ADPT160M.HAM SLOT=201 /LUNS
LOAD ADPT160M.HAM SLOT=202 /LUNS
6.
After the STARTUP.NCF file has been edited, save the file and reboot the server to activate the new STARTUP.NCF.
7.
Upon reboot navigate to the System Console and type scan all. This will start a scan of all the LUNS on each adapter.
8.
When the scan is complete, verify the LUN device has been detected using the list storage adapters command.
Typical output with both the tape drive and loader being recognized:
0x08 [V321-A3] Adaptec SCSI Card 39160/3960D - Ultra160 SCSI [slot 201]
0x16 [V321-A3-D5:1] DELL PV-124T 0031
0x15 [V321-A3-D5:0] QUANTUM ULTRIUM 3 xxxx
0x09 [V321-A4] Adaptec SCSI Card 39160/3960D - Ultra160 SCSI [slot 202]
Netware may display unbound device, meaning a driver is not bound to the loader unless a driver from a backup software is loaded. This does not
prevent the backup application from detecting the LUN and binding the appropriate driver.
Back to Contents Page
NOTE: The user must type the command scan all upon OS boot every time. If backup software services automatically start on OS boot,
the user must disable them, run the scan all command, and re-enable the services.
NOTE: Netware may display unbound device meaning a driver is not bound to the loader unless a driver from a backup software is
loaded. This does not prevent the backup application from detecting the LUN and binding the appropriate driver.