Before contacting customer support – Dell PowerVault 124T User Manual
Page 41
Back to Contents Page
Troubleshooting: Dell™ PowerVault™ 124T LTO3
-060 Autoloader User's Guide
Before Contacting Customer Support
Operator Control Panel Error Display
Returning the Autoloader for Service
Before Contacting Customer Support
Errors that you may experience with your autoloader can range from simple connection problems to more complex hardware failure. Before you return your
autoloader, you may be able to fix the problem yourself by following some basic troubleshooting procedures.
Other than drive cleaning, there is no recommended routine maintenance of the Dell PowerVault 124T autoloader.
The operator control panel located at the front of the autoloader provides some troubleshooting capabilities, but is limited. The Remote Management Unit
provides more detailed information about the present state of the autoloader and past performance, and is more helpful for troubleshooting errors.
The following table describes the probable cause and suggested action for problems that you may encounter.
Table 1: Basic Troubleshooting
NOTICE: If you find that you must power cycle the autoloader, do not turn the power back on for at least 10 seconds after powering
down. This allows time for the power supply to completely discharge and ensure a complete system reset. If time is not allowed for the
discharge, the system may fail to boot properly and will display a blank LCD screen. Power cycle again, waiting at least 10 seconds, to
clear the problem.
Problem
Probable Cause
Suggested Action
The front panel does not display
information.
The connection to the LCD has failed.
l
Use the
Remote Management Unit
to troubleshoot error.
Error messages appear on the
front panel LCD display.
An error has occurred.
l
Refer to
The autoloader is operating
slowly.
The autoloader, system hardware, or
host backup software is incorrectly
configured.
l
The autoloader does not turn on. The power cable is defective or the
power source is malfunctioning. The
power switch at the back of the
autoloader is not turned on.
l
Check all outlets and power cables for proper connection.
l
Check the power switch at the back of the autoloader.
l
Contact
The front panel does not display
information, but light indicators
above the front panel are turned
on.
A momentary power interruption
allowed the autoloader to power off,
then back on prior to the power supply
being fully discharged.
l
On the front panel, press and hold the power switch for 15 seconds, then
turn the rear power switch off. Wait 60 seconds and turn the rear power
switch back on.
l
Contact
The autoloader does not
communicate with the host
system through the SCSI bus.
A problem within the SCSI cabling path
is preventing communication.
l
Verify that the SCSI cables are connected to the rear of the autoloader
and that the correct LVD host controller card is installed.
l
Verify that the SCSI cables are not damaged or crimped and the total SCSI
cable length is not exceeding the maximum required length.
l
Verify that a LVD SCSI terminator is attached to both the first and last
SCSI device on the SCSI bus.
l
Verify that the autoloader SCSI ID is set to a unique SCSI ID that is not
used by any other SCSI device on the same SCSI bus.
l
Verify that the host bus adapter is supported for use with the Dell
.
l
Issue an Autoloader Reset either by using the
Remote Management Unit
Diagnostic
page or by turning off power from the front panel.
l
Contact
The tape drive responds on the
A system configuration problem is
l
If the SCSI ID is unique, check SCSI cable and terminator connections.