Installing a raid controller card, Connecting the card – Dell PowerEdge 1850 User Manual
Page 61
14.
Install and configure the RAID software.
See the RAID software documentation for more information.
Installing a RAID Controller Card
See "
Installing an Expansion Card
" in "Installing System Components" for instructions about installing the card. See the RAID controller documentation for
information on installing and configuring the RAID software.
Connecting the Card
After installing the card, connect the card to the system's SCSI backplane using the new SCSI cable supplied with the card.The new cable replaces the cable
extending from the riser card to the connector on the underside of the SCSI backplane.
Back to Contents Page
NOTICE:
A newly-installed RAID battery must be charged for three to four hours of system operation before you can operate the RAID controller in
write-back mode.