C. Crane CC Radio 2 - Manual (Page 11)

CCRadio 2 Page 11
Radio Operation
Manual Tuning
1) Press the Power Button to turn on the radio.
2) Select the band by pressing the Band Button.
3) A single press of the Up or Down Tuning Buttons will
change the frequency up or down for AM, FM and Ham
(VHF) bands, and channel up or down for Weather.
Each press of Up and Down Tuning Buttons will change the frequency
by 10 kHz in AM mode, 100 kHz in FM mode, and 5 kHz in Ham (VHF).
Scan Tuning
Same as above except press and hold the Tuning Up or Down
Button for more than 0.5 second. The radio will scan and stop
automatically when it finds an active station. The Scan Tuning
will not work on the weather band. It may also stop scanning on strong
interference or noise. Press and hold again to resume. For 2-Meter
Ham scanning, please see page 14 for more advanced information.
Rotary Tuning
Rotating the tuning knob will change AM/FM/Ham (VHF) by frequency
and the weather band by channel.
Memory Tuning
Five stations may be stored into memory in
each of the four bands.
1) Tune to the station or channel you want to memorize.
2) Press and Hold the desired Memory Button for two seconds or
until you hear a beep. The station or channel is then memorized.
The display will show the memory number.
To recall the memorized station, select the correct band and briefly
press and release the Memory Button. The radio will instantly tune to
the station stored in memory.
Note:
The CCRadio2 automatically fine tunes the Twin Coil Ferrite ® AM
Antenna for a few seconds after a station is changed in AM mode. The
“signal” icon will flash during this time.
The CCRadio2 features four bands: AM / FM / 2-Meter Ham (VHF) and
Weather.
TUNING