C. Crane CC Radio 2 - Manual (Page 16)

Page 16 CCRadio 2
Radio Operation
The Lock switch can be used when transport-
ing the radio to prevent accidentally turning it
on. When the switch is pushed up you will see
the Lock symbol appear on the display.
It can also be used to disable all functions of
the radio when it is turned on. Push the
switch down to release the lock for
normal operation.
You can use a stereo or mono headphone with a 3.5
mm plug. When you insert the headphone plug, the speaker is discon-
nected. This radio delivers FM in stereo through the headphones.
Once in a while glitches may occur on any portable digital radio. This
can be caused by static electricity, unusual key strokes or a power dis-
ruption. If this happens, use the end of a paper clip or ball point pen and
push it into the hole briefly to reset the radio. You will lose the clock
time and all the stations stored in memory when the radio is reset.
Reset Button
Bottom View
of CCRadio2
Display Light on AC Power
When the radio is plugged into AC power, the display light will always
be on unless you turn it off. The special green LED bulbs last about
100,000 hours and use very little electrical energy. The display light has
three light levels. If you want to change the light level or turn off
the display light, press and release the Light button until you
reach the desired level. Refer to page 5 for button identification.
Display Light on Batteries
When batteries are used, the display light can be turned on by pressing
the light button. The display light automatically goes off 2 minutes after
the last time you press any button.
LOCK SWITCH
HEADPHONE JACK
RESET BUTTON
DISPLAY LIGHT
Lock
Switch
Headphone
Jack
Right Side View