Clarion DXZ925 - Manual (Page 14)

18
DXZ925
280-7752-00
English
Radio Operations
FM reception
For enhanced FM performance the ®
tuner includes signal actuated stereo control,
Enhanced Multi AGC, Impulse noise reduction
curcuits and Multipath noise reduction circuits.
Changing the reception area
This unit is initially set to USA frequency intervals
of 10kHz for AM and 200kHz for FM. When using it
outside the USA, the frequency reception range
can be switched to the intervals below.
●Setting the reception area
1. Press the [BND] button and select the de-
sired radio band (FM or AM).
2. While pressing the [DISP] button, each time
you press and hold the number “6” of the [DI-
RECT] buttons for 2 seconds or longer, the
reception area switches from inside the USA
to outside the USA or from outside the USA
to inside the USA.
∗ Any station preset memories are lost when the
reception area is changed.
Listening to the radio
1. Press the [FNC] button and select the radio
mode. The frequency or PS appears in the
display.
∗ PS: Programme service name
2. Press the [BND] button and select the radio
band. Each time the button is pressed, the ra-
dio reception band changes in the following
order:
FM1 ➜ FM2 ➜ FM3 ➜ AM ➜ FM1...
3. Press the [ a] or [d] button to tune in the
desired station.
Tuning
There are 3 types of tuning mode available, seek
tuning, manual tuning and preset tuning.
Operation P.EQ
A full range of frequency level can be minutely
corrected with a smooth curve by frequency cor-
rection in accordance with car models. Six kinds
of P.EQ basic menus have been pre-stored in
this unit according to the car models and the
mounting positions of speakers. Thus, set it in
accordance with the car type.
1. Press the [EQ] button to enter “P.EQ” mode.
2. Press the Band button to select “P.EQ BA-
SIC”.
3. Press the [DIRECT] button to select P.EQ
menu as below.
1.SEDAN-1 2.SEDAN-2 3.WAGON-1
4.WAGON-2 5.MINI VAN-1 6.MINI VAN-2
4. Press the [EQ] button to return to the previ-
ous mode.
5. Press and hold the [EQ] button for 1 second
or longer so that the P.EQ effect is turned on
or off.
Adjusting P.EQ
1. Select “P.EQ” menu which you want to edit
on the basis of.
2. Press and hold the [TITLE] button for 1 sec-
ond or longer.
3. Press the [ a] or [d] button to select item
to be adjusted.
There are “FRONT/REAR” ,“BAND” ,“FREQ”
“GAIN” and “Q” available for the items ad-
justed.
5. Press and hold the [DIRECT] buttons for 2
seconds or longer to store the edited con-
tents.
∗ You can give a title to user memory. For the in-
putting method of titles, refer to the subsection
“Entering titles” in section “Operations com-
mon to each mode”.
∗ The parameter created in this section is also
effective when the unit is in both the “STD”
and “PRO” mode.
AC-Processor II Operations
280-7752-00_Eng 12/12/01, 6:37 PM 18