Dell 7330dn Mono Laser Printer User Manual
Page 71
Additional PJL Commands
Dell 7330 Mono Laser Printer System Administrator Guide
B-6
@PJL XPERSONALJOB
n/a
Starts a Personal Print job.
@PJL XPROOFJOB
n/a
Starts a Proof Print job.
@PJL XSAVEDJOB
n/a
Starts a Saved Print job.
@PJL XSECUREJOB
n/a
Starts a Secure Print job.
@PJL XIGNOREFF
ON, OFF
Ignores FormFeed commands when
printing PCL blank pages.
@PJL XLINETERMINATION=value
ON, OFF
Terminates a line.
@PJL XMBFSIZE=value
ANY or any
supported media
size, such as
LETTER,
STATEMENT, and
EXECUTIVE
Sets the media size for Tray 1.
@PJL XMEDIASOURCE=value
ANY, TRAYn
Sets the media source.
@PJL XMEDIATYPE=value
ANY or any
supported media
type, such as PAPER
and LABEL
Sets the media type.
@PJL XPCLTRAYSWITCH=value
ON, OFF
Switches trays when a tray becomes
empty. If AutoSelect is chosen as
the paper source (tray) in PCL, then
tray switching is always active,
regardless of the value. When the
current tray becomes empty, the
printer attempts to switch to another
tray containing the same size and
type of paper. This command only
takes effect when a specific tray,
such as Tray 2, is selected in the job.
When this command is ON, tray
switching still occurs when the tray
becomes empty. When this
command is OFF, no switching
occurs and the user is prompted to
load paper.
@PJL XPCLPAPERSRCx = y
x is 0, 1, 2, 3, 4, 5, 6,
7, 8, 20, 21, 22, 23,
which is the number
in the <Esc>&l#H
tray selection
commands
y is -1 for
AutoSelect, 0 for the
current tray (eject
page), 1 for Tray 1, 2
for Tray 2, etc., and
99 for the factory
defaults
Overrides the tray selected in the
<Esc>&l#H PCL tray selection
commands.
PJL Command
Values
Description