Dell PowerVault MD3220i - Manual (Page 72)

72 Appendix—Manual Configuration of iSCSI
If you are using Windows Server 2008 Core Version:
1 Set the iSCSI initiator services to start automatically (if not already set):
sc \\<server_name> config msiscsi start= auto
2 Start the iSCSI service (if necessary): sc start msiscsi
3 Log on to the target:
iscsicli PersistentLoginTarget <Target_Name>
<Report_To_PNP> <Target_Portal_Address>
<TCP_Port_Number_Of_Target_Portal> * * *
<Login_Flags> * * * * * <Username> <Password>
<Authtype> * <Mapping_Count>
where
–
<Target_Name> is the target name as displayed in the target list. Use
the iscsicli ListTargets command to display the target list.
– <Report_To_PNP> is T, which exposes the LUN to the operating
system as a storage device.
– <Target_Portal_Address> is the IP address of the iSCSI port on the
controller being logged in to.
– <TCP_Port_Number_Of_Target_Portal> is 3260.
– <Login_Flags> is 0x2 to enable multipathing for the target on the
initiator. This value allows more than one session to be logged in to a
target at one time.
– <Username> is the initiator name.
– <Password> is the target CHAP secret.
– <Authtype> is either 0 for no authentication, 1 for Target CHAP, or 2
for Mutual CHAP.
: NOTE:
<Username>
, <Password> and <Authtype> are optional parameters.
They can be replaced with an asterisk (*) if CHAP is not used.
– <Mapping_Count> is 0, indicating that no mappings are specified
and no further parameters are required.
* * * An asterisk (*) represents the default value of a parameter.
book.book Page 72 Sunday, September 11, 2011 10:24 PM