Canon OPTURA10 - Manual (Page 70)

70
Using the Full Range
of Featur
es
❍ Low sound may be reduced together with the wind noise. We recommend
turning off the wind screen for normal recordings.
❍ The wind screen function cannot be turned on/off during recording.
❍ The wind screen function can also be used for audio dubbing (when [AUDIO
DUB.] is set to [MIC. IN] in the [AUDIO SET UP] submenu).
❍ The wind screen function cannot be used when an external microphone is
connected to the MIC terminal or when the DM-50 Microphone is attached to
the advanced accessory shoe.
Using Headphones during Recording
You can use headphones to monitor the sound during recording.
When using headphones, make sure that “
H” is displayed. If “H” is not displayed
change the setting following the procedure below.
Switching the AV/Headphones Terminal
Open the menu and select [VCR SET UP]. Select [AV/PHONES], set it to [AV]
or [PHONES
H ] and close the menu.
Adjusting the Headphone Volume
Open the menu and select [AUDIO SET UP]. Select [
H VOLUME], adjust
the volume with the selector dial and close the menu.
You can turn off the volume completely by turning the selector dial down until [OFF]
appears. Turn the selector dial up to increase the volume again.
CARD PLAY (VCR) CARD CAMERA PLAY (VCR) CAMERA
CARD PLAY (VCR) CARD CAMERA PLAY (VCR) CAMERA
E
AV/PHONES••••AV VCR SET UP
( 43)
HVOLUME•••••
AUDIO SET UP
( 43)