Clarity DECT6.0 - Manual (Page 12)

20 21
Make a Call
1. Pre-dialing
Enter the phone number first, then press <TALK ON/FLASH> or
<SPEAKER> to dial out the number. Press <TALK OFF/CLEAR> or
<MUTE/X> to clear the entry.
2. Direct Dialing
Press <TALK ON/FLASH> or <SPEAKER> to access dial tone, then enter
the phone number.
3. Dial a speed dial number
In idle mode, press and hold a dial pad key (0 through 9) to display the
desired speed dial entry.
The handset automatically dials out the displayed number.
- OR -
Press <TALK OFF/CLEAR> to stop dialing the displayed number.
Note: You need to set the speed dial number first. If the speed dial
location you selected is empty, the screen shows the speed dial list
instead.
4. Call from Directory
1. In idle mode, press <UP> to access the directory. Alternatively, press
<MENU/SELECT> twice to access the directory from the main menu.
2. Press <UP> or <DOWN> to select the desired directory entry.
3. Press<TALK ON/FLASH> or <SPEAKER> to dial out to the selected
entry.
5. Call from the Call Log
1. In idle mode, press <DOWN> to access the call log.
2. Press<UP/DOWN> to select the desired call log entry.
3. Press <TALK ON / FLASH> or <SPEAKER> to dial out to the
selected entry.
6. Call from the Redial List
1. In idle mode, press <REDIAL/PAUSE> to access the redial list.
2. Press <UP> or <DOWN> to select the desired redial number.
3. Press <TALK ON/FLASH> or <SPEAKER> to dial out to the selected
number.
Note:
Your handset automatically times the duration of every call. The call
timer will display a few seconds after the call has been made. It is shown
in hours, minutes and seconds format.
Temporary tone dialing
If you have pulse (rotary) dialing service only, you can temporarily switch from
pulse to touch-tone dialing during a call.
During a call, press <*>. Buttons pressed after this send touch-tone signals. The
telephone automatically returns to pulse dialing mode after you end the call.
Answer a Call
When the phone rings, press <TALK ON / FLASH> to use the earpiece
- OR -
Press <SPEAKER > to use the speakerphone.
End a Call
During a call connection on handset, press <TALK OFF/ CLEAR> to end
the call.
- OR -
Put the handset on the base station to end the call.
USING YOUR PHONE USING YOUR PHONE