Dell XPS 730 H2C (Late 2008) - Manual (Page 10)

18. Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
19. Rotate the graphics card bridge back into its original position; push its tip so that its tab clicks into place.
20. If present, lower the graphics card bridge that lays over the installed cards and snap it into place.
21. Replace the computer cover (see Replacing the Computer Cover ), reconnect the computer and devices to electrical outlets, and then turn them on.
22. Install any drivers required for the card as described in the card documentation.
Back to Contents Page
1 card connector (seated) 2 card connector (not seated)
3 bracket properly aligned within
slot
4 bracket improperly aligned outside of
slot
5 alignment bar 6 alignment guide
CAUTION: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly
or cause damage to the equipment.
CAUTION: An incorrectly attached graphics power cable may result in degraded graphics performance.
CAUTION: Before rotating the card retainer back into place, ensure that the tops of all cards and filler brackets are flush with the alignment bar
and the notch in the top of each card or filler bracket fits around the alignment guide.