Dell 1420X Projector - Manual (Page 41)

Power Settings
Select and press to activate power settings. The power settings menu consists
of the following options:
Advanced Settings Dell 1420X
Image Settings Quick Shutdown Off
Display Settings Power Saving 10 Min
Projector Settings Lamp Mode Normal
Menu Settings Lamp Hour Reset Press
Power Settings
Information
Resolution: 1440x1050
Q UICK S HUTDOWN —Select On to turn off the projector with a single press of
the Power button. This function allows the projector to quick power off
with an accelerated fan speed. Slightly higher acoustic noise is expected
during quick power off.
NOTE: Before you turn on the projector again, wait for 60 seconds to allow the
internal temperature to stabilize. The projector will take a longer time to turn on
if you try to power on immediately. Its cooling fan will run at full speed for about
30 seconds to stabilize the internal temperature.
P OWER S AVING — Select Off to disable Power Saving mode. By default, the
projector is set to enter power saving mode after 10 minutes of no activity.
A warning message appears on screen showing a 60-second countdown
before switching to power saving mode. Press any key buttons during
countdown period to stop power saving mode.
You can also set a different delay period to enter power saving mode. The
delay period is the time you want the projector to wait without an input
signal. Power saving can be set to 30, 60, 90, or 120 minutes.
If an input signal is not detected during the delay period, the projector
Using Your Projector 41