Dell PowerEdge M710HD - Manual (Page 236)

236 Installing Blade Components
Installing an Expansion Card
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2 Open the blade. See "Opening the Blade" on page 159.
3 If installed, remove the expansion-card blank:
a Loosen the captive screw and open the filler-bracket retention latch by
rotating the latch open. See Figure 3-36.
b Rotate the expansion-card retention latch away from the blank until it
snaps into position under the securing tab. See Figure 3-36.
c Grasp the expansion-card blank and remove it from the expansion-
card connector. See Figure 3-36.
4 Remove the metal filler bracket out of the blade.
5 Locate the expansion-card connector on the riser.
6 Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector.
7 Insert the card-edge connector firmly into the expansion-card connector
until the card is fully seated.
Additionally for NVIDIA M1060 GPGPU card, push the shipping lock up
and snap into place. The shipping lock and the locking tab are installed on
systems installed with a NVIDIA M1060 GPGPU card.
8 Lift the latch-release tab and rotate the expansion-card retention latch
toward the expansion card. The retention latch holds the full-height
expansion card in position. See Figure 3-36.
9 Close the filler-bracket retention latch and tighten the captive screw. See
Figure 3-36.