Dell OptiPlex 360 (Late 2008) - Manual (Page 133)

Troubleshooting 133
Steady
Green
A possible expansion
card failure has
occurred.
• Determine if a conflict exists by
removing an expansion card (not a
graphics card) and restarting the
computer (see the "Cards" section for
your computer).
• If the problem persists, reinstall the
card you removed, then remove a
different card and restart the
computer.
• Repeat this process for each expansion
card installed. If the computer starts
normally, troubleshoot the last card
removed from the computer for
resource conflicts.
• If the problem persists, contact Dell
(see "Contacting Dell" on page 159).
Steady
Green
Another failure has
occurred.
• Ensure all hard drive and optical drive
cables are properly connected to the
system board (see the "System Board
Components" section for your
computer).
• If there is an error message on the
screen identifying a problem with a
device (such as the floppy drive or
hard drive), check the device to make
sure it is functioning properly.
• If the operating system is attempting
to boot from a device (such as the
floppy drive or optical drive), check
system setup to ensure the boot
sequence is correct for the devices
installed on your computer.
• If the problem persists, contact Dell
(see "Contacting Dell" on page 159).
Light Pattern Problem Description Suggested Resolution