Crestron electronic QUICK MEDIA DISTRIBUTION CENTER QM-MD4X2 - Manual (Page 33)

Crestron QM-MD4x2 QuickMedia Distribution System
3. Select the input to be switched by pressing its corresponding button.
4. Select the destination(s) where the signal is to be switched. If an
output’s LED is lit, the input signal will be routed there. To disable a
routing destination, press the output button again. The LED will turn
off.
NOTE: If a button-press causes a change to the current switching
schema, the ENTER LED will flash rapidly.
5. Press ENTER to enable the new signal routes. The ENTER LED will
turn off.
6. Repeat for other input signals to be switched.
NOTE: Changes made on the front panel are made only after the ENTER button is
pressed.
Switching Audio & Video Separately:
1. Make sure that the MD4x2 is in the local mode (the LOCAL LED is
flashing slowly).
2. Enable the audio break function by pressing AUDIO BREAK. When
audio break is enabled, the AUDIO BREAK and A LEDs will
illuminate.
3. Select the audio portion of an input to be switched by pressing its
corresponding button.
4. Select the destination(s) where the audio portion of the signal is to be
switched. If an output’s LED is lit, the input signal will be routed there.
To disable a routing destination, press the output button again. The
LED will turn off.
NOTE: If a button-press causes a change to the current switching
architecture, the ENTER LED will flash rapidly.
5. Press V to switch the video portion of the signal.
6. Select the destination(s) where the video portion of the signal is to be
switched. If an output’s LED is lit, the input signal will be routed there.
To disable a routing destination, press the output button again. The
LED will turn off.
7. Press ENTER to enable the new signal routes. The ENTER LED will
turn off.
8. Repeat for other input signals to be switched.
NOTE: Changes made on the front panel are made only after the ENTER button is
pressed.
Operations Guide - DOC. 6278 QuickMedia Distribution System: QM-MD4x2 • 29