CLIFFORD 330.3X - Manual (Page 28)

25 © 2009 Directed Electronics. All rights reserved.
Prepare the system
Open 1. a door.
Turn 2. the ignition on.
Press 3. and release then press and hold the control center button.
The control center LED flashes and the siren chirps one time to
confirm the system is prepared.
Release
4. the control center button and proceed below.
Note: Begin pairing within 60 seconds or the system will exit (indi-
cated by a long siren chirp) and will need to be prepared again.
Prepare the remote control
Select the desired Car 1 (Default) or Car 2 operation before proceed-
ing.
Press 1. and hold the button of the remote control until a long
beep is emitted and
MAIN MENU
is displayed (If programmed to
operate two systems, confirm the correct car 1 or car 2 text and
beeps at 3 seconds).
Release the
2. button to view the main menu.
REMOTE SETUP
is
displayed.
Press
3. and release the button two times.
PAIR REMOTE
is
displayed.
Press
4. and hold the button until
PAIR
is displayed, and then
release it.
Press
5. and hold the button until the siren emits a long chirp.
SUCCESS
is displayed with a sequence of chimes.
Note: If
FAILED
is displayed, make sure the system is still pre-
pared and repeat step 5 until successful.
Demo Mode:
Demo mode plays a pre-selected group of animations as a demonstra-