CLIFFORD 330.3X - Manual (Page 39)

36 © 2009 Directed Electronics. All rights reserved.
Using the 1-way Companion remote
The 1-way companion remote commands the system features as
shown in the previous table, but only transmits and does not provide
feedback as with the 2-way remote control. Siren chirps and parking
light flashes are used to indicate that a command has been received
and activated as described in the Basic Commands and Advanced
Commands sections.
Accessing Commands
Similar to the Responder LC remote, basic commands are performed
when a command button is pressed directly. To perform advanced
commands press the
button one to four times to access function
levels. For example; x4 in the table implies pressing four times
to reach level 4. The transmit LED flashes in groups of 1 to 4 for a few
seconds to indicate the respective level. Press the desired command
button while the transmit LED is flashing to perform the command.
Button Auto Lock
When on, the remote control buttons lock if more than 20 seconds
lapses between button presses. If a button is pressed when locked,
the remote control appears to be non-operational and will not transmit
a command or illuminate the transmit LED. To unlock the buttons; press
the
button followed by the button.
Car Select
Car 2 must first be turned on (See Remote Features menu under Pro-
gramming section below to turn on). Press and hold the button
for 3 seconds. The remote flashes the transmit LED once or twice to
indicate the selected car is 1 or 2.
Release the button, then press and release while the transmit
LED flashes to perform car select. Once the car is selected a command