Dell W5300 Workgroup Laser Printer - Manual (Page 138)

Queuing Jobs
The printer is sending one or
more held jobs to print. Wait for the message to clear.
See also: Using the Print and Hold function
Ready
The printer is ready to receive
and process print jobs. Send a job to print.
Ready Hex
The printer is in Hex Trace mode
and is ready to receive and
process print jobs. Send a job to print. All data sent to
the printer is printed in hexadecimal
and character representation.
Control strings are printed, not
executed.
Turn the printer off and then on to
exit Hex Trace mode and return to
Ready status.
Reattach
<device>
The envelope feeder is either not
fully connected to the printer or is
experiencing a hardware failure. Reestablish communication by
removing the envelope feeder and
reattaching it to the printer.
Press Go to clear the message and
continue printing without using the
envelope feeder.
In the case of a hardware failure,
turn the printer off and back on. If
the error recurs, turn the printer off,
remove the envelope feeder, and call
Dell at support.dell.com.
See also: Contacting service
Remove Paper
<standard bin>
The output bin is full. Remove the stack of paper from the
standard bin to clear the message.
Res Reduced
The printer is reducing the
resolution of a page in the current
job from 600 dots per inch (dpi)
to 300 dpi to prevent a
38 Memory Full
error. Res
Reduced remains on the display
while the job prints.
Press Menu to open the Job Menu and
cancel the current job.
Resetting
Maint Cnt Value
The printer is resetting the
counter that tracks wear on the
fuser. Wait for the message to clear.
Resetting the
Printer
The printer is resetting to the
current default settings. Any
active print jobs are canceled. Wait for the message to clear.
See also: Using the operator panel to
change printer settings
The printer is restoring the Wait for the message to clear.