Dell OptiPlex GX260 - Manual (Page 99)

Installing a Floppy Drive
1. If the replacement drive does not have the bracket rails attached, remove the rails from the old drive by removing the
two screws that secure each rail to the drive. Attach the bracket to the new drive by aligning the screw holes on the
drive with the screw holes on the bracket rails and then inserting and tightening all four screws (two screws on each
rail).
Floppy Drive Bracket Rails
1 drive
2 bracket rails (2)
3 screws (4)
2. Gently slide the drive into place until the tabs securely click into position.
3. Attach the power and floppy-drive cables to the floppy drive.
4. Connect the other end of the floppy-drive cable to the connector labeled DSKT on the system board.
Attaching Power and Drive Cables