Dell M110 Projector - Manual (Page 34)

W HITE I NTENSITY —Press and use and to display white
intensity.
NOTE:
1 If you adjust the settings for Brightness, Contrast, Color Temperature,
Saturation, Sharpness, Tint, and White Intensity the projector automatically
switches to Custom mode.
2 Saturation, Sharpness, and Tint are only available when input source is from
A/V in.
D ISPLAY S ETTINGS (I N PC M ODE )— Select and press to activate display settings.
The display settings menu provides the following options:
H ORIZONTAL P OSITION —Press to move the image right and to
move the image left.
V
ERTICAL P OSITION —Press to move the image up and to move
the image down.
F
REQUENCY —Allows you to change the display data clock frequency to
match the frequency of your computer’s graphics card. If you see a
vertical flickering wave, use the Frequency control to minimize the
bars. This is a coarse adjustment.
T
RACKING —Synchronize the phase of the display signal with the
graphic card. If you experience an unstable or flickering image, use
the Tracking to correct it. This is a fine adjustment.
A
SPECT R ATIO —Allows you to select the aspect ratio to adjust how the
image appears. Options are: Origin, 16:9, and 4:3.
• Original — Select Origin to maintain the aspect ratio of the image
projector according to the input source.
• 16:9 — The input source scales to fit the width of the screen to project a
16:9 screen image.
Using Your Projector 34