General troubleshooting, Eneral, Roubleshooting – Chauvet INTIMIDATOR DMX-605A User Manual

Page 14: Symptom solution(s)

Advertising
background image

Appendix

DMX-605A & DMX-610A User Manual

14

2005-11-16/16:16

General Troubleshooting

Applies to

Symptom

Solution(s)

Lights

Foggers

& Snow

Controllers

Dimmers

& Chaser

Auto shut off

Check fan thermal switch reset

Beam is very dim or not
bright

Clean optical system or replace lamp

Check 220/110v switch for proper setting

Breaker/Fuse keeps
blowing

Check total load placed on device

Chase is too slow

Check users manual for speed adjustment

Device has no power

Check for power on Mains.

Check device

’s fuse. (internal and/or external)

Fixture is not responding

Check DMX Dip switch settings for correct addressing
Check DMX cables
Check polarity switch settings

Fixture is on but there is
no movement to the audio

Make sure you have the correct audio mode on the control switches.
If audio provided via

¼” jack, make sure a live audio signal exists

Adjust sound sensitivity knob

Lamps cuts off
sporadically

Possible bad lamp or fixture is overheating.

Lamp may be at end of its life.

Light will not come on after
power failure

Some discharge lamps require a cooling off period before the
electronics in the fixture can kick start it again, wait 5 to 10 minutes
before powering up

Loss of signal

Use only DMX cables

Install terminator
Note: Keep DMX cables separated from power cables or black lights.

Motor movements are
jerky or jumpy

Possible bad motor driver or sensors

Check polarity switch on controller

Moves slow

Check 220/110v switch for proper setting

No flash

Re-install bulb, may have shifted in shipping

No light output

Check slip ring & brushes for contact

Install bulb

Call service technician

Relay will not work

Check reset switch

Check cable connections

Remote does not work

Make sure connector is firmly connected to device

Stand alone mode

All CHAUVET lighting fixtures featuring stand-alone functions do not
require additional settings, simply power the fixture and it will
automatically enter into this mode

Unit wobbles when rotating

Check for damages possibly incurred during shipping

Advertising
This manual is related to the following products: