Setup, Lamp, Lamp installation – Chauvet INTIMIDATOR DMX-605A User Manual
Page 6: Power, Ower, Etup
DMX-605A & DMX-610A User Manual
6
2005-11-16/16:16
Lamp
exposed
Remove both thumbscrews
Lamp Installation
Slide switch up or down
depending on your line voltage.
S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. An ELC 250W halogen lamp
is included.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
L AM P I N ST AL L AT I O N
1)
Remove both thumbscrews located on the front of
the fixture next to the focus lens and remove the
lamp face plate.
2)
If replacing the lamp, remove old lamp first.
3)
Reach in and slide the lamp out of the retaining
cage.
4)
Detach the lamp from the lamp socket and replace.
5)
Replace lamp face plate, align the screw holes and
fasten the thumbscrews.
6)
No lamp alignment is necessary for this fixture
since the lamp is already optimized inside the
reflector.
Power
Your product is equipped with switch-selectable AC
power setting.
Warning!
Verify that the power select switch on your unit matches the line voltage applied. All
fixtures must be connected to circuits with a suitable Earth Ground.
To determine the power requirements for a particular fixture, see the label
affixed to the back plate of the fixture or refer to the fixture
’s specifications
chart.
A fixture
’s listed current rating is its
average current draw under normal
conditions.
All fixtures must be powered directly off a switched circuit and cannot be run off a
rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is
used solely for a 0% to 100% switch.
Before applying power to a fixture, check that the source voltage matches the fixture
’s
requirement.
All fixtures must be connected to circuits with a suitable Earth Ground.