Chauvet INTIMIDATOR DMX-605A - Manual (Page 7)

Setup
DMX-605A & DMX-610A User Manual 7 2005-11-16/16:16
Hanging Clamp
Note!
Clamp is sold separately.
Rotate lens
gun clockwise
and counter-
clockwise to
achieve
desired focus.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
Mounting
O R I E N T AT I O N
This fixture may be mounted in any position provided there is adequate room for ventilation.
R I G G I N G
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable
“C” or “O” type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
o
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
o
Safety cables should always be used.
o
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature
changes or restricted ventilation.
Manual Focusing
To adjust the focus, please follow the instructions below.
1) If operating in stand alone mode, turn the music
down so that the unit temporarily stops any activity.
2) In DMX control mode, create a static scene with
any gobo of your choice pointed to a flat surface,
ideally at a half-way point of the fixtures total
coverage area.
Rotate the lens gun either clockwise or counter-
clockwise until the spot is defined by a hard edge.
Fuse Replacement
With a flat head screwdriver wedge the fuse
holder out of its housing. Remove the damaged
fuse from its holder and replace with exact
same type fuse. Insert the fuse holder back in
its place and reconnect power.
Disconnect the power cord before replacing a fuse and
always replace with the same type fuse.