Char-Broil 415.9011211 - Manual (Page 20)

*This side UP
Tank heat shield
13
Inside of cart, insert rear shield into left slot(#1) on top of lower back panel. Insert left grease tray rail into slot(#2) beneath
with two #8x3/8” self-tapping screws, shown B. Insert right grease tray rail into slot(#3) and attach it under front brace(#6)
with one #8x3/8” self-tapping screws, shown A/B.
Rear
Front
20
Tank heat shield
Tank heat shield
Cart lower back panel
Right rail
Left rail
Front Brace
Right rail
Left rail
#8x3/8”
self-tapping screw
Grease tray opening
grease tray opening in upper back panel, shown A. Attach front shield and left grease tray rail under front brace(#4 and #5)
for clarity of illustration
Note: some parts omitted
A
B
#8x3/8” self-tapping screw
Qty.3
12
Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and
facing the front. Secure using two 1/4-20x1½” screws, 7mm lock washers, and 7mm flat washers on each side.
1/4-20x1½”
screw
7mm lock
washer
7mm flat
washer
Door
Hinge Pin
Front brace
1/4-20x1½”
7mm Lock washer
screw
Qty.4
Qty.4 Qty.4
7mm flat washer
#2 #3
#4
#5
#6
#1