Char-Broil 415.9011211 - Manual (Page 21)

15
21
Wire
1
2
3
4
5
(a)
(b)
ignition module
Electronic
Right side panel
B
A
Nut
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module. Total (5) connections. Connect the two wires{(a)and(b)} from the switch wiring harness into the back of the Electronic
Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart right side panel with
the nut, shown B. Insert AA battery into ignition module, negative ( – ) end first. Then put on the cap, shown C.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown
as (a), (b). Do not untie the wires while attaching.
14
Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of
door, and release hinge pin into door.
Hinge pin
on bottom
of door
Top of
door
PRESS
Left door
Right door
+
-
Cap
AA battery
Right side panel
C
Ignition Module. Total (2) connections, shown A.