Dell Alienware 17 (Mid 2013) - Manual (Page 92)

Replacing the Processor | 92
Replacing the Processor
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before Working Inside Your Computer" on page 11. After working
inside your computer, follow the instructions in "After Working Inside
Your Computer" on page 13.
For more safety best practices, see the Regulatory Compliance
home page at dell.com/regulatory_compliance.
Procedure
NOTE: If a new processor is installed, you will receive a new thermal-cooling
assembly, which will include an affixed thermal pad, or you will receive a new thermal
pad along with documentation to illustrate proper installation.
1 Align the pin-1 corner of the processor with the pin-1 corner of the ZIF socket,
then place the processor in the ZIF-socket.
NOTE: The pin-1 corner of the processor has a triangle that aligns with the
triangle on the pin-1 corner of the ZIF socket. When the processor is properly
seated, all four corners are aligned at the same height. If one or more corners of
the processor are higher than the others, the processor is not seated properly.
CAUTION: To prevent intermittent contact between the ZIF-socket
cam screw and the processor when replacing the processor, press to
apply slight pressure to the center of the processor while turning the
cam screw.
CAUTION: To avoid damage to the processor, hold the screwdriver
perpendicular to the processor when turning the cam screw.
book.book Page 92 Friday, June 28, 2013 3:27 PM