Dell Brocade Adapters - Manual (Page 239)

Brocade Adapters Installation and Reference Manual 211
53-1002144-01
Network driver parameters
A
Network driver parameters
The driver configuration parameters are global parameters used by all network driver instances.
The default values for the driver configuration parameters are compiled into the driver. Network
drivers are only used for CNAs and for Fabric Adapter ports configured in CNA or NIC mode.
The driver-level configuration values discussed in this section are in the following locations on your
system:
• Linux - /etc/modprobe.conf
• VMware - /etc/vmware/esx.conf
• Windows - Device Manager
NOTE
These parameters are should only be changed from the default values by power users with great
caution.
Windows
Table 37 describes the instance-specific network configuration parameters available for Windows
hosts.
TABLE 37 Network driver configuration parameters
Function Default Value Possible Values Method to Configure Notes
Autorecovery Disable Enable
Disable Device Manager Supported on Windows Server
2003 and 2008
FlowControl,
Transmit (Tx) and
Receive (Rx) Enable Enable
Disable Device Manager Enables 802.3x flow control
for Windows 2008 only.
Interrupt
Moderation Enable Enable
Disable Device Manager
IPv4 Checksum
Offload Enable Enable
Disable Device Manager Supported on Windows Server
2003 and 2008 for IPv4
traffic.
Jumbo Packet Size 1500 1500-9000 Device Manager Sets MTU size. Size must not
be greater than size set on
FCoE switch
Large
Segmentation
Offload V1 IPv4
(LSOv1) Enable Enable
Disable Device Manager Supported on Windows Server
2003 and 2008 for IPv4
traffic.
Large
Segmentation
Offload V2 IPv4
(LSOv2) Enable Enable
Disable Device Manager Supported on Windows Server
2003 and 2008 for IPv4
traffic.
Large
Segmentation
Offload V2 IPv6
(LSOv2) Enable Enable
Disable Device Manager Supported on Windows Server
2003 and 2008 for IPv4
traffic.