Compex Systems 802.11N - Manual (Page 48)

Spanning Tree Setup
Spanning Tree Protocol: Default is disabled. Check on box to enable.
Root Priority: Default value is 32768. Smaller value has higher priority.
Root Hello Time: Default time is 2 seconds.
Root Forward Delay: Default is 15 seconds
Root Maximum Age: Default is 20 seconds
Changing to lower time can caused high overheads to the network.
NAT Setup
NAT: Enabled when in Router mode. Disabled when in Bridge mode.
DMZ: Default is disabled. Check on box to enable.
DMZ IP Address: Input IP address of the local PC to receive the DMZ packets.
Port Forwarding: Default is disabled. Check on box to enable.
For configuration refer to Appendix section.
Adding an entry from Known Server
Add entry from this box and select an application the list.
Server Type: click to select the application you want to add.
Private IP Address: Enter the local IP of the PC running the application
Public IP Address: If the application to for any people on the internet to access then
select the default, All.
If only specific IP, select Single and enter the IP address.
If only specific range of IP, select Range and enter IP address range.