Dell PowerEdge T105 User Manual
Page 65
Installing System Components
65
3 Disconnect the hard drive power cable from the hard drive that you are
removing.
4 Disconnect the blue data cable from the hard drive that you are removing
by pulling up on the blue tab.
5 Press the blue tabs on each side of the hard-drive bracket toward each
other and slide the drive and its bracket up and out of the bay. See
Figure 3-14.
Figure 3-14.
Removing and Installing a Hard Drive in the Drive Carrier
NOTE:
If you do not intend to replace the drive, it is highly recommended that you
remove the drive from the guide bracket (see Figure 3-15) and insert the empty
guide bracket back into the drive bay. This eliminates the likelihood that the empty
bracket will be misplaced or improperly stored while not in use.
1
hard drive power cable
2
hard drive in primary hard drive bay
1
2
book.book Page 65 Wednesday, April 15, 2009 8:47 PM