Dell PowerEdge T105 - Manual (Page 77)

Installing System Components
77
• Integrated PCI devices (such as NICs) and SCSI controllers
• PCI expansion cards
At start-up, the BIOS identifies the components that require address space.
The BIOS dynamically calculates the amount of reserved address space
required. The BIOS then subtracts the reserved address space from 8 GB to
determine the amount of usable space.
• If the total installed system memory is less than the usable space, all
installed system memory is available for use only by the operating system.
• If the total installed system memory is equal to or greater than the usable
address space, a small portion of installed memory is available for use by
the operating system.
Removing a Memory Module
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer and protecting against
electrostatic discharge.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 47.
3 Press out on the securing clip at each end of the memory module
connector. See Figure 3-20.
4 Grasp the memory module and pull it out of the connector.
If the module is difficult to remove, gently move the module back and
forth to remove it from the connector.
Installing a Memory Module
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer and protecting against
electrostatic discharge.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
book.book Page 77 Wednesday, April 15, 2009 8:47 PM