Attach the emergency release rope andhandle, Installation step 9, Attach the emergency release rope and handle – Chamberlain WHISPER DRIVE 248754 User Manual

Page 19

Advertising
background image

19

To prevent possible SERIOUS INJURY or DEATH from
a falling garage door:
• If possible, use emergency release handle to

disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.

• NEVER use emergency release handle unless

garage doorway is clear of persons and
obstructions.

• NEVER use handle to pull door open or closed. If

rope knot becomes untied, you could fall.

INSTALLATION STEP 9

Attach the Emergency Release Rope and
Handle

• Thread one end of the rope through the hole in the

top of the red handle so “NOTICE” reads right side
up as shown. Secure with an overhand knot at least
1" (2.5 cm) from the end of the rope to prevent slipping.

• Thread the other end of the rope through the hole in the

release arm of the outer trolley.

• Adjust rope length so the handle is 6 feet (1.8 m) above

the fl oor. Ensure that the rope and handle clear the tops
of all vehicles to avoid entanglement. Secure with an
overhand knot.

NOTE: If it is necessary to cut the rope, heat seal the cut
end with a match or lighter to prevent unraveling.

Trolley
Release Arm

Overhand
Knot

Emergency
Release Handle

Trolley

Advertising