Chamberlain WHISPER DRIVE 248754 - Manual (Page 38)

38
PROGRAMMING
NOTICE: If this Security✚ ® garage door opener is operated with a non-rolling code remote control, the technical measure
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
remote control to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The
door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional 315 MHz Security✚ ® remote controls.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON USING THE DOOR CONTROL
1. Press and hold the button on the
hand-held remote* that you wish
to operate your garage door.
2. While holding the remote button,
press and hold the LIGHT button
on the door control.
3. Continue holding both buttons
while you press the push bar
on the door control (all three
buttons are held).
4. Release buttons when the motor
unit lights blink. It has learned
the code. If light bulbs are not
installed, two clicks will be heard.
1. Press and release the “learn”
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-held
remote* that you wish to operate
your garage door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, fi rst erase all
codes:
Press and hold the “learn” button on
motor unit until the learn indicator
light goes out (approximately
6 seconds). All previous codes are
now erased. Reprogram each remote
or keyless entry you wish to use.
*3-Button Remotes (315 MHz)
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any Security✚
®
3-button remote or
mini-remote can be
programmed to operate
other Security✚
® garage
door openers.