Cuisinart DGB-700 - Manual (Page 8)


CONTROL PANEL
1. On/Off button with LED Indicator
a. Audible Tone
The Fully Automatic Burr Grind &
Brew™ Coffeemaker is equipped with
an audible tone which will sound 5 times
when the coffee has completed brewing
(coffee may continue to stream from the
filter for several seconds afterward).
b. Auto Off
The auto off feature is used to shut off
the coffeemaker at a preset time, any-
where from 0 to 4 hours.
2. Hour and Minute Buttons
Press and hold either Hour or Min for
approximately 2 seconds to enter Time Set
Mode.
3. Clock/LCD Display
Displays time of day or Auto On time.
Displays Strength Control setting (MILD,
MED or STRONG).
4. Program Button with LED Indicator
Press to display or set Auto On time.
5. Grind Off Button with LED Indicator
Use to turn off the grinder when using
pre-ground coffee.
6. Grind Control Knob
Turn the Grind Control to choose the
desired amount of coffee beans to grind.
7. Strength Control Button
Press to choose coffee strength: mild,
medium, or strong. Selected coffee
strength will show on Clock Display.
PROGRAMMING YOUR
COFFEEMAKER
Setting the Clock
When the coffeemaker is plugged in, 12:00 will
appear until you set the time.
Entering Time Set Mode
To set the time, hold down either the Hour or
Minute button until the clock begins flashing
(about 2 seconds). You are now in the Time Set
mode and can operate either button to select
the desired time. The buttons can be held down
to scroll through the digits, or pressed and
released to advance one digit at a time. When
scrolling, the numbers will advance slowly at
first and then speed up to the rate of about
three per second. When the number displayed
approaches the desired time, release the button
and press repeatedly to advance one digit at a
time. Be careful to make sure that the PM
indicator is on if a PM time is desired.
Exiting Time Set Mode
The Time Set mode can be exited in one of two
ways:
1. Press any button besides the Hour or
Minute button. This will exit the Time Set
mode and activate the selected function.
2. Do nothing. If neither the Hour or Minute
button is pressed for a period of five sec-
onds, the Time Set mode will be exited.
Setting the Program Time
When you press the Program Set button, it
displays the current auto on time (default time
12:00 pm).
Entering Set Program Time Mode
Press and hold the Program Set button (about
2 seconds) until the green light and LCD display
begin to flash. This signals that you have
entered the Set Program Time mode. The