Califone DVD-110 - Manual (Page 6)

califone.com califone.com
8
SKIP FORWARD (NEXT)
Press this key to skip to the next chapter or next song.
STEP
This button pauses playback. Then every time it is pressed, playback
proceeds one frame at a time.
SLOW
Press this key when the disc is playing to play the images/frames slowly.
You can select the speed of 1/2X, 1/3X, 1/4X, 1/5X, 1/6X, and 1/7X.
STOP
Press this key once to pause, and then press [ ] to continue playing.
Press this key twice continuously to stop playback entirely.
MUTE
Press this key to mute the audio. Press again to unmute the audio.
R/L
When playing a VCD, press this key to switch between left and right
speakers.
N/P
Press this button to switch between NTSC and PAL outputs.
RESET
Press this button to reset the settings to factory default.
DVD / USB
To switch between different sources, first stop playback of the DVD.
Then press the DVD/USB key. Next, use the up/down keys to select the
desired signal source.
VOLUME + / -
Press [VOL +] to increase volume, press [VOL-] to reduce the volume.
VIDEO
Press this button set the video settings.
califone.com
9
5. SETUP & INSTALLATION
5.1 REMOTE CONTROL BATTERY INSTALLATION
1. Open the battery compartment cover and insert two AAA alkaline
batteries inside the battery compartment. Follow the polarity as
indicated in the battery compartment.
2. Close the battery compartment cover.
Caution:
• Do not attempt to recharge, short-circuit, disassemble, heat or
throw the batteries into a fire.
• During extended storage please be sure to remove batteries
from remote to avoid possible damage caused by leakage and/or
corrosion.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
batteries.
• Do not try to recharge batteries that are not intended to be
recharged; they can overheat and rupture. (Follow the battery
manufacturer’s directions).
• Dispose of old batteries properly in accordance with local laws.
Low Battery
When batteries are low the remote will not function properly and
the batteries must be replaced.
5.2 CONNECT TO TELEVISION / SOUND SYSTEM
1. Connect Video Output (RCA / S-Video / Component) to Video input
of TV or monitor.
2. Connect Analog Audio Outputs using RCA cables (red on top,
white on bottom) to the audio input of the TV or PA / sound system.
Optionally, connect the COAX output from the DVD player to the
Digital Audio input of the PA / sound system.
DVD-110 User Manual - JH 2009.11.23.indd 8-9 11/23/2009 10:59:32 AM