Chamberlain TCR2 - Manual (Page 3)

3
OUTPUT RELAYS & CONFIGURATION SWITCH SETTINGS
Figure 2
Delta-3/ Linear
Multi-Code
Stanley
310 MHz
300 MHz
310 MHz
TM
TM
TM
Configuration
Switch
Setting the Configuration Switch
The TriCode ® receiver is factory set for Linear/Delta-3 TM .
Locate the configuration switch and set it to the desired RF mode
of operation (Figures 2 and 3). Modes are as follows:
Linear/Delta-3 TM : works with all “Linear/Delta-3 TM ” transmitters
transmitted at 310 MHz using 8-bits ID system.
Multi TM : works with all “Multi-Code TM ” transmitters transmitted at
300 MHz using 10-bits ID system.
Stanley TM : works with all “Stanley TM radio” transmitters
transmitted at 310 MHz using 10-bits ID system.
Setting Output Relay Mode
The TriCode ® receiver is factory set for momentary relay output
“MNT”.
• Momentary mode: The output relay will be on for .5 seconds
before turning off.
• Constant pressure mode: Output relay is continuously on
while receiving matching/valid ID code from transmitter. The
output relay will turn off immediately once receiver does not
receive a matching/valid ID code from the transmitter
(Figure 3).
NOTE: If constant pressure mode is desired, open front cover
and move mode jumper from “MNT” to “CST” (Figure 2).
Figure 3
CH1
MODE
CST MNT
CH2
MODE
CST MNT
Relay
CH1-mode
Relay
CH2-mode
Configuration
Switch
Delta-3/Linear
Multi-Code
Stanley TM
TM
TM
LINEAR
MULTI
STAN
TM
TM
TM
CH2
MODE CST MNT CH1
MODE
CST MNT