Clarion VDH910 - Manual (Page 7)

2 (Front AV Inputs) using the Remote control.
4 STEREO IN L/R LINE-1 (RCA Jacks)
Use a stereo RCA audio cable to connect stereo audio from an
alternate A/V source. You can choose either audio source
LINE 1 or LINE 2 (Front A/V Inputs) using the Remote
control.
5 DC IN 12V (4-Pin Molex)
Use the supplied DC power cord to connect the VDH910
to the vehicle’s 12-volt electrical system.
6 REMOTE SENSOR INPUT (3.5 mm Plug)
Install and connect the remote mount IR Sensor (included)
to the back of the VDH910 when the player is hidden
away or mounted under a seat.
7 RF INPUT (F-Connector)
Use with a 75 ohm antenna.
8 RF OUTPUT (F-Connector)
Route to 75 ohm TV input.
OWNER’S MANUAL/INSTALLATION GUIDE
5
Figure 1. The VDH910’s rear connections.
D
ESCRIPTION
O
F
R
EAR
C
ONNECTORS
1 STEREO L/R OUTPUT (RCA Jacks)
Use a stereo RCA audio cable to connect stereo audio from
the VDH910.
2 VIDEO OUT (RCA Jack)
Use an RCA video cable to connect video from the
VDH910 to the Monitor.
3 VIDEO IN LINE-1 (RCA Jack)
Use an RCA video cable to connect a video input signal
to the VDH910. You can choose either LINE 1 or LINE