Cuisinart CSB-78 - Manual (Page 12)

12
Position the two mounting holes of the wall bracket over the
screw heads, and slide wall bracket down the wall until the
bracket is resting against the screw head, and will not slide any
further. If the wall bracket feels too loose against the wall,
remove bracket, put screws further into wall, and replace
bracket.
Place the assembled hand blender into the wall bracket. The
unit will hang from the bracket, held in place by the motor body
width.
The charger handle can be attached to the motor body when
you store the unit. This is especially helpful when you want the
hand blender close at hand during a period of heavy use. At
other times, keep the charger handle plugged into the electrical
socket to assure the battery is always 100% charged.
CLEANING
Always clean the hand blender thoroughly after using.
HAND BLENDER
Detach the charger handle from the motor body before
cleaning. Remove the shaft with the blade from the motor body.
The shaft with the blade can be cleaned by hand in hot water
with a mild detergent. It is not necessary to remove the blade
from the shaft. Do not use abrasive cleansers which could
scratch the surface.
Clean the motor body and the charger handle with a sponge or
damp cloth only. Do not use abrasive cleansers which could
scratch the surface.
The mixing/measuring beaker can be cleaned in the dishwasher
(upper rack) or by hand in hot water with a mild detergent.
Never immerse the motor body or charger handle in water.
CHOPPER/GRINDER ATTACHMENT
To simplify cleaning, rinse the prep bowl, cover and blade
immediately after use, so that food won’t dry onto them. Wash
blade ring, plastic sheath, and prep bowl in warm soapy water.
Rinse and dry. Wipe the underside of the chopper/grinder cover
with a sponge or damp cloth to remove any food. Do not
submerge the cover in water or place in the dishwasher.
Wash the blade carefully. Avoid leaving it in soapy water where
it may disappear from sight.
If you have a dishwasher, you can wash the prep bowl and
blade assembly on the upper shelf. Insert the prep bowl upside
down. Put the blade in the cutlery basket. Unload the
dishwasher carefully to avoid contact with the sharp blade.
Wipe the top cover with a damp sponge or cloth. Dry it
immediately.
The chopper/grinder attachment is intended for HOUSEHOLD
USE ONLY. Any service, other than cleaning and normal user
maintenance, should be performed by an authorized Cuisinart
Service Representative.
WHISK ATTACHMENT
To clean your whisk attachment, simply release the attachment
from the motor body housing. Once the whisk is removed,
detach the metal whisk from the gearbox by pulling pieces
apart. To clean the gearbox, simply wipe with a damp cloth. To
clean the metal whisk, wash with warm, soapy water or place in
the dishwasher. Do not submerge the gearbox in water or any
other liquid.
DISPOSAL/RECYCLING
OF BATTERIES
This product uses four nickel-cadmium rechargeable and
recyclable batteries. At the end of the batteries’ useful life, they
should be recycled. These batteries must not be incinerated or
composted.
Nickel-cadmium batteries should not be put in municipal waste
systems. Contact your local waste collection agency for proper
recycling and disposal information for your area.
Please do not attempt to dismantle the charger handle to
replace these batteries on your own. Damage could result to
the unit.
When it is time to replace and/or recycle the batteries, or to
receive additional instructions for disposing of old batteries, call
toll-free 1-800-726-0190 to order a new charger handle which
will include the four new batteries. Or send the charger handle
to Cuisinart, 150 Milford Road, E. Windsor, NJ 08520.